![]() Normative references are formal parts of the standard. The section also explains when reference should be made to the standard and when to revert to International Standards. Under the general section, this part of the standard reiterates the importance of workshop accuracy in determining tolerance class. angular and linear dimensions referred by other standards. ![]() Angular dimensions for uniform polygons (unless there is reference to IS0 2768-2)ĭimensions not covered in this part of the standard are:.Angular and linear dimensions for machined assembled parts.Part 1 applies to three dimensions as listed below: The seven topics covered in this document are: Note that dimensions should not have individual tolerance indication. As mentioned in the introduction, this section deals with general tolerances for angular and linear dimensions. This part of the standard has the crucial role of simplifying drawing indications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |